> CONNECTIVITY > FULL INVERTER TECHNOLOGY Thanks to Fluidra Pool app intuitive interface, connect and control easily the heat pump remotely (and other Fluidra products ; see chapter Internet of Pools) from anywhere at any time with a smartphone. Fluidra Pool app is GDPR compliant (General Data Protection Regulation) to ensure the personal data protection. Full Inverter technology enables a heat pump to change its power mode depending on the pool heating needs. It therefore runs to achieve the best energy efficiency at the lowest noise level. Full inverter Technology with 3 operating modes : • Boost: Maximum power for quick heating at the beginning of the season • Smart: Automatic power adjustment between Ecosilence and Boost • Ecosilence: Greater energy savings and lower noise level HEAT PUMPS Main features > AUTOMATIC COOLING MODE For pools with liners, it is not recommended to maintain the temperature of the water in the pool at a higher temperature than +30°C to prevent water quality from deteriorating, turning green and damaging the liner. In hot areas, during hot seasons or if the pool is equipped with a shelter, it is common that the pool water temperature can exceed +30°C. A heat pump with an automatic cooling mode will stabilize the pool water temperature at the desired target. BRING CONNECTIVITY WITH IQBRIDGE RS iQBridge RS is a plug & play WiFi gateway to easily connect some of the heat pumps (see comparative tables) to the homeowner WiFi network and benefit from Fluidra Pooll app control experience. See « Internet of Pools » section for more details about iQBridge RS and FluidraPool app benefits. > DEFROSTING PRINCIPLE When the outside temperature is low, the evaporator will tend to ice up, which reduces its efficiency: this ice must therefore be removed by cycle inversion. The refrigerating circuit is reversed, heat from the water in the pool is taken to defrost the evaporator. Defrosting allows an extended / full year use. HEATING AND COOLING 291
RkJQdWJsaXNoZXIy NDg2ODU=